TOPIC: Tether cars/ engines need accomplished mill machine work!

Tether cars/ engines need accomplished mill machine work! 2 months 1 week ago #153

  • Democh
  • Democh's Avatar
  • Offline
  • New Member
  • Posts: 4
Been building cars for 20 years on H F 3 in 1, finally reached my level of incompetence!
Need someone capable of mill work on al castings to surface engine/gearbox mounts,
Bore bearing holes, etc..
Very good potential for full size mill work future. Please reply or refer candidates to:
This email address is being protected from spambots. You need JavaScript enabled to view it.
The administrator has disabled public write access.

Tether cars/ engines need accomplished mill machine work! 1 month 3 weeks ago #155

  • 777engman
  • 777engman's Avatar
  • Offline
  • New Member
  • Posts: 6
just wondering if you have found a milling machine operator yet? if not I could probably help you out.
let me know
cheers
Dean
The administrator has disabled public write access.

Tether cars/ engines need accomplished mill machine work! 1 month 3 weeks ago #159

  • Democh
  • Democh's Avatar
  • Offline
  • New Member
  • Posts: 4
Thanks for reply! Where you located? What kind of Mill you have?
We race these cars near Rosemead. Regards, Rich Democh
(This email address is being protected from spambots. You need JavaScript enabled to view it.)
The administrator has disabled public write access.

Tether cars/ engines need accomplished mill machine work! 1 month 3 weeks ago #160

  • 777engman
  • 777engman's Avatar
  • Offline
  • New Member
  • Posts: 6
Hi there, I have my own machine shop and can do most anything in the smaller operation requirements. I live in New Zealand so the only limiting factor size wise would be what was shippable. I will send you some photos of projects done so far to give you a better idea of what I can do.
Reagrds
Dean
The administrator has disabled public write access.

Tether cars/ engines need accomplished mill machine work! 1 month 2 weeks ago #162

  • Democh
  • Democh's Avatar
  • Offline
  • New Member
  • Posts: 4
Where were you a month ago? One of the items I need done is an incomplete
Gear box case I sourced from Australia! Thanks for your kind offer of help, but I am so far behind now that the logistics of shipping, etc. is a deal breaker for me!
I would think considerable of this work is available over there. (See Australian tether car racing site, ref. Scott Clydesdale) Many Thanks for offer of Help, Rick
The administrator has disabled public write access.
Time to create page: 0.169 seconds
Powered by Kunena Forum